Specialty
Metal Detector Product Line
Our specialty
products are solutions to specific customer applications unable to be met by
our standard products. Every special product is not listed here as
Tectron’s success in providing solutions for tough applications continually
expands our line of products. Our application skills and design knowledge can
provide a specific solution for your needs.
Under
Belt Model "FlatPak" General Purpose Model
5700 Metal Detector
This unit is
comprised of a single antenna for mounting underneath a conveyor belt.
The Model 5700 is best suited for applications requiring an clear space
above the conveyor belt due to the odd shaped conveyed material or material of
varying height. Optimum detection depends on the metal lying on or in
close to the belt. Maximum detector capability is dependent on multiple
factors and should be evaluated for each application.
Under
Belt Model "FlatPak" High Sensitivity Model
9300 Metal Detector
Designed
specifically for applications where the detection of small pieces of metal is
required and the area above the belt must remain unobstructed.
The Model 9300 detects both magnetic and non-magnetic tramp metals and
can be sized to suit almost any installation.
Long
Object Model
6000 Metal Detector
Designed to
prevent conveyor belt piercing by long rods (such as roof bolts) or jamming of
the transfer point, the Model 6000 selectively detects long metal
objects of a given diameter and length as well as normal tramp metals greater
than the given rod diameter. As with most Tectron units, the detector is
also compatible with fabric or steel cord conveyor belts, and belts with metal
splices.
The
Discriminator Model
8050 Metal Detector
Has the unique
ability to detect and discriminate between non-magnetic and
magnetic tramp metals. Typically, the Model 8050 is installed on a
conveyor system in conjunction with a magnetic separator. The detector
can be set to detect all non-magnetic tramp metals and those pieces of magnetic
tramp metal, which are too large for or missed by the magnet.
Whole log Model
9100 Metal Detector
The Model 9100
is designed for applications where large sensing apertures and high metal
sensitivity are required. It is particularly suited to scanning whole
logs on conveyors or chutes. Maximum detector sensitivity is generally
1.5% of the aperture height. The Model 9100 has shielded receiver
and transmitter antennae to minimize interference from surrounding metal and
airborne electrical transmissions.
|
